Viewpoint

Modulated superfluid density in an iron-pnictide superconductor

    John M. Tranquada
    • Condensed Matter Physics & Materials Science Department, Brookhaven National Laboratory, Upton, NY 11973-5000, USA
Physics 3, 41
Measurements with a scanning probe microscope sensitive to micron-scale magnetization variations provide evidence for stripes of enhanced superfluid density at the surface of an iron-pnictide superconductor.
Illustration: Alan Stonebraker, adapted from [11]
Figure 1: Phase diagram for Ba(Fe1xCox)2. Yellow indicates the superconducting phase, which appears below the superconducting transition temperature Tc. A structural transition occurs at Ts from the tetragonal phase (Tet) at higher temperature to the orthorhombic phase (Ort). Blue represents the antiferromagnetic order (AFM), which appears at TN, slightly below Ts for finite x. The stripes of enhanced superfluid density are observed only in the regime 0.04<x<0.06.

Studies of the iron-pnictide materials have dominated the field of superconductivity for the last two years. While several different families of iron-based superconductors have been discovered, they all tend to exhibit antiferromagnetic order that gives way to superconductivity when the electron density is tuned by adjusting the chemical composition, thus leading to obvious comparisons with copper-oxide superconductors [1]. The superconductor family Ba(Fe1-xCox)2As2 has received particular attention because in these materials antiferromagnetic order and superconductivity coexist over a range of cobalt concentrations. Using a scanning probe technique, Beena Kalitsky, John Kirtley, and collaborators at Stanford University and at the IBM Watson Research Center, New York, both in the US, report in two papers in Physical Review B compelling evidence that the superfluid density is not uniform in this phase, showing an enhancement along stripes corresponding to boundaries between rotated crystal domains [2,3]. The fact that the superconducting transition temperature Tc is a maximum at the cobalt concentration where the enhanced stripes just disappear suggests that the interactions involved in the magnetic order and structural distortions are important for the electron pairing, but their ordering competes with the superconducting transition.

One of the key properties of a superconductor is its ability to screen magnetic fields. When a magnetic field is applied to a superconducting object, supercurrents develop at the surfaces that cancel the magnetic field in the interior of the object. The magnetic field will decay exponentially with distance from the object’s surface, with a characteristic penetration depth λ. The higher the density of superconducting carriers, ns, the better the screening and the shorter the magnetic penetration depth; more quantitatively, ns1/λ2. If one applies a magnetic field near the surface of a superconductor and measures the net field as a result of the screening, it is possible to determine λ and hence ns.

To perform such a measurement with high spatial resolution, the researchers used a scanning SQUID microscope [4]. The sensor involves a tiny ( 4μm diameter) loop of superconducting wire. The presence of any magnetic flux within the loop will modify the critical current, the amount of current that can pass through the SQUID without creating a voltage. The critical current is controlled in a feedback loop to produce a signal proportional to the magnetic flux. To generate a magnetic field for probing, a wire loop of larger diameter surrounds the sensor loop. The field at the sensor position is modified by proximity to the surface of the superconducting sample. Knowing the height of the sensor loop above the superconducting surface, it is then possible to determine the magnetic penetration depth from the net magnetic field at the sensor. By rastering the SQUID across a surface, it is possible to map out variations in λ.

To appreciate what has been measured, we have to turn to the phase diagram for Ba(Fe1-xCox)2As2 (Fig. 1), which has been worked out by several groups using a variety of experimental techniques [5–7]. The crystal structure of this material contains iron-arsenic layers; at high temperature, the iron atoms in a layer form a square lattice, corresponding to a tetragonal crystal structure. For x0.06, the square lattice distorts to rectangular (orthorhombic crystal symmetry) on cooling, with antiferromagnetic order developing at a slightly lower temperature. When an iron layer transforms from square to rectangular symmetry, there are two possible equivalent orientations of the rectangular axes, and generally both types of “twin” domains will be present. For the scanning SQUID measurements, Kalisky et al. [2] observe parallel stripes of reduced penetration depth only in orthorhombic samples and not in ones with tetragonal symmetry. The stripes have a width of 9μm (limited by experimental resolution, as determined by modeling [3]) and a typical separation of roughly 15μm. Based on the orientation and spacing of the stripes, Kalisky et al. argue that the superconducting stripes are associated with the domain walls where pairs of structural twin domains meet. Performing simulations by finite-element analysis, Kirtley et al. [3] show that the measurements are consistent with a three-dimensional (3D) model in which the stripes are just the cross section of sheets of enhanced superfluid density; these sheets could correspond to the planes formed at the intersection of pairs of 3D twin domains.

The orthorhombic phase for x0.06 has received considerable attention recently. Chu et al. [8] have shown that uniaxial pressure can be used to select a single orthorhombic domain, and that the electrical resistivity parallel to the Fe- As layers shows a surprisingly strong anisotropy. Electronic anisotropy has also been detected by scanning tunneling spectroscopy in the closely related compound Ca(Fe1-xCox)2As2 [9]. These anisotropic responses are clearly associated with the orthorhombic domains themselves and not with the boundaries between domains. Recent neutron diffraction studies of the ordered magnetic moments [10] and the orthorhombic strain [11] indicate that both of these quantities decrease when the temperature is lowered through the superconducting Tc. The decreased magnetic order parameter could possibly result from the development of a nonmagnetic phase at the twin-domain boundaries, but the reduction in orthorhombic strain suggests that the superconducting order prefers regions with reduced electronic anisotropy. The latter point could be consistent with enhanced superfluid density at the twin boundaries, where the strain is presumably relaxed completely.

It should be noted that there are a few experiments on other iron-pnictide compounds that have provided evidence for spatial inhomogeneity. For example, nuclear magnetic resonance (NMR) studies using As nuclei have found evidence for two distinct arsenic environments in LaFeAsO1-xFx for x in an underdoped superconducting regime, close to the magnetic phase but without static magnetic order [12]. Another arsenic NMR study on SrFe2As2 at high pressure found evidence for separate but coexisting domains of magnetic order and superconductivity [13]. Then there is a study on Ba1-xKxFe2As2 carried out with muon-spin-rotation spectroscopy and magnetic force microscopy that suggests phase separation into antiferromagnetic and superconducting domains with a characteristic length scale of 65nm [14].

While the scanning SQUID experiment reveals inhomogeneity, it also indicates that all regions of the sample are superconducting. One of the most intriguing observations is that the stripe contrast increases on warming towards Tc [2]. In attempts to model this behavior, the best agreement is obtained by assuming that the stripes of higher superfluid density also have a higher Tc [3], even though each sample seems to show a single, bulk superconducting transition. Intriguingly, a new paper has just appeared [15] reporting the results of point-contact tunneling spectroscopy on a film of Ba(Fe1-xCox)2As2 with x=0.04 that show a spectroscopic signature of superconducting pairs at temperatures as high as 1.3Tc. Might these incoherent pairs be associated with the positions of the stripes that appear below Tc?

Returning to the phase diagram for Ba(Fe1-xCox)2As2, the maximum Tc occurs just at the point where the orthorhombic strain, magnetic order, and stripe contrast disappear. The position of the Tc maximum suggests that the interactions that lead to the ordering (structural and magnetic) instabilities are good for superconductivity, as long as one can suppress those orderings. This situation is reminiscent of the superconductors with the A-15 structure, such as Nb3Sn and V3Si [16]. In that case, the lattice instability towards a symmetry-lowering phase transition is believed to also be responsible for the relatively high Tc, but the occurrence of the structural transition probably limits Tc. For the iron-based superconductors, magnetism and the degeneracy of certain Fe 3d orbitals are factors believed to be highly relevant to the mechanism of electron pairing. Adjusting the electron density is clearly one way to tune the interactions and optimize Tc. The search for other ways to optimize Tc will surely continue.

References

  1. M. R. Norman, Physics 1, 21 (2008)
  2. B. Kalisky, J. R. Kirtley, J. G. Analytis, J-H. Chu, A. Vailionis, I. R. Fisher, and K. A. Moler, Phys. Rev. B 81, 184513 (2010)
  3. J. R. Kirtley, B. Kalisky, L. Luan, and K. A. Moler, Phys. Rev. B 81, 184514 (2010)
  4. http://en.wikipedia.org/wiki/Scanning SQUID microscope
  5. N. Ni, M. E. Tillman, J.-Q. Yan, A. Kracher, S. T. Hannahs, S. L. Bud’ko, and P. C. Canfield, Phys. Rev. B 78, 214515 (2008)
  6. F. Ning, K. Ahilan, T. Imai, A. S. Sefat, R. Jin, M. A. McGuire, B. C. Sales, and D. Mandrus, J. Phys. Soc. Jpn. 78, 013711 (2009)
  7. J.-H. Chu, J. G. Analytis, C. Kucharczyk, and I. R. Fisher, Phys. Rev. B 79, 014506 (2009)
  8. J.-H. Chu, J. G. Analytis, K. D. Greve, P. L. McMahon, Z. Islam, Y. Yamamoto, and I. R. Fisher, arXiv:1002.3364v2
  9. T.-M. Chuang, M. P. Allan, J. Lee, Y. Xie, N. Ni, S. L. Bud’ko, G. S. Boebinger, P. C. Canfield, and J. C. Davis, Science 327, 181 (2010)
  10. R. M. Fernandes, D. K. Pratt, W. Tian, J. Zarestky, A. Kreyssig, S. Nandi, M. G. Kim, A. Thaler, N. Ni, P. C. Canfield, R. J. McQueeney, J. Schmalian, and A. I. Goldman, Phys. Rev. B 81, 140501 (2010)
  11. S. Nandi, M. G. Kim, A. Kreyssig, R. M. Fernandes, D. K. Pratt, A. Thaler, N. Ni, S. L. Bud’ko, P. C. Canfield, J. Schmalian, R. J. McQueeney, and A. I. Goldman, Phys. Rev. Lett. 104, 057006 (2010)
  12. G. Lang, H.-J. Grafe, D. Paar, F. Hammerath, K. Manthey, G. Behr, J.Werner, and B. Büchner, Phys. Rev. Lett. 104, 097001 (2010)
  13. K. Kitagawa, N. Katayama, H. Gotou, T. Yagi, K. Ohgushi, T. Matsumoto, Y. Uwatoko, and M. Takigawa, Phys. Rev. Lett. 103, 257002 (2009)
  14. J. T. Park, D. S. Inosov, C. Niedermayer, G. L. Sun, D. Haug, N. B. Christensen, R. Dinnebier, A. V. Boris, A. J. Drew, L. Schulz, T. Shapoval, U. Wolff, V. Neu, X. Yang, C. T. Lin, B. Keimer, and V. Hinkov, Phys. Rev. Lett. 102, 117006 (2009)
  15. G. Sheet, M. Mehta, D. A. Dikin, S. Lee, C. Bark, J. Jiang, J. D. Weiss, E. E. Hellstrom, M. Rzchowski, C. Eom, and V. Chandrasekhar, arXiv:1004.4852v1
  16. L. R. Testardi, Rev. Mod. Phys. 47, 637 (1975)

About the Author

Image of John M. Tranquada

John Tranquada is leader of the neutron scattering group at Brookhaven National Lab and a principal investigator in the Center for Emergent Superconductivity, an Energy Frontier Research Center. He received his B.A. and Ph.D. in physics from Pomona College and the University of Washington, respectively. He continues to enjoy studying high-temperature superconductors, primarily with neutron scattering techniques.


Subject Areas

Superconductivity

Related Articles

Zero-Resistance State for a Potential High-Temperature Superconducting Nickelate
Superconductivity

Zero-Resistance State for a Potential High-Temperature Superconducting Nickelate

Researchers have measured a zero-resistance state for the nickelate La3Ni2O7, which measurements suggest may superconduct at temperatures above the boiling point of liquid nitrogen. Read More »

Composite Fermions Are Better Together
Quantum Physics

Composite Fermions Are Better Together

Particle pairing seen in nanoscale semiconductor devices could point the way to materials that superconduct at high temperatures. Read More »

Device Could Lead to New Current-Measurement Standard
Superconductivity

Device Could Lead to New Current-Measurement Standard

High-precision measurements of the oscillations generated by a superconducting device suggest that an improved electric-current-calibration standard should be possible. Read More »

More Articles